How to Replace Your IGNITE Module Enclosure

If your IGNITE i36 or i18 module enclosure is damaged or needs replacement, you can replace it using a compatible housing provided by IGNITE. The process is straightforward and requires only basic tools.

Follow the steps below to remove your old enclosure and install a new one. If you prefer to have our team perform the repair, contact IGNITE Support for assistance.

Step 1: Remove the 4 corner screws

Using a Phillips screwdriver, remove the four corner screws on the back of the module that hold the two halves of the enclosure together.

Step 2: Remove the antenna connector

Turn the module over. Using a 5/16" wrench, carefully remove the antenna nut and lock washer. Set them aside for reinstallation.

Step 3: Separate the enclosure halves

Once the screws and antenna are removed, lift the top half of the enclosure to expose the internal components of your module.

Step 4: Remove the circuit board

Remove the four screws securing the circuit board to the bottom half of the enclosure. Gently unplug the small harness connected to the power button underneath the board.

Step 5: Remove the power button

From inside the enclosure, push the power button outward. It’s held in place by a tension clip and should release with light pressure.

Step 6: Reassemble your module

Once the enclosure has been replaced, reassemble your module by following these steps in reverse. Make sure all connections are secure and the antenna and screws are firmly tightened.

Caution:

Take care not to pinch cables or overtighten screws during reassembly. If your module does not power on after replacing the enclosure, contact IGNITE Support for troubleshooting.

Need more help? Contact us, we're always happy to assist!