How to Check Connected Igniters for Continuity with IGNITE Lite – IGNITE Firing Systems

Applies to:

IGNITE IGNITE Lite

Not sure which you have? What is IGNITE Lite?

Before firing your show, you need to check that all your igniters are properly connected and functioning. A continuity check sends a small current through the igniters to confirm that the circuit between the module and igniter is complete. No continuity can indicate a faulty igniter, or a broken coil due to poor installation. Completing this step ensures your system is ready to fire, providing confidence in your setup.

Hardware Version Differences

The process for checking continuity depends on your IGNITE Lite module hardware version. Refer to the table below:

Hardware Version	Continuity Check Method
Lower than 2.0	Automatic – Continuity is checked and updated automatically.
2.0 or higher	Manual – Users must manually tap "Check Igniters" for an updated status.

To find out which hardware version you have, see How to Find Your IGNITE Lite Module Hardware Version

The change to the continuity check process enhances safety by giving you control over when the module is sending any sort of current through the igniters. For more information on continuity, check out What Is Continuity, and Why Is It Important?

Step 1: Open the Manual Fire screen.

Open the IGNITE Lite App and tap Manual Fire.

IGNITE Lite Home Screen Box Around Manual Fire.jpg

Step 2: Check igniters.

Locate and tap the Check Igniters button at the bottom of the screen.

IGNITE Lite Manual Fire Screen Box Around Check Igniters.jpg

Step 3: Review the Safety Warning.

After tapping the Check Igniters button, a safety warning will appear. Review and follow the safety instructions, then tap Ok to proceed.

IGNITE Lite Check Igniters Safety Warning.jpg

Step 4: Wait for the Continuity Check to complete.

The Check Igniters button will say Checking... instead while the app takes a few moments to update continuity.

IGNITE Lite Continuity Check In Progress.jpg

Step 5: View continuity results.

The module's continuity status will now be displayed. Cues with continuity will appear in green.

IGNITE Lite Manual Fire Screen All Cues Green.jpg

Tip:

Continuity does not update automatically on newer hardware versions. If you add igniters after checking, run the check again.

Troubleshooting Continuity Issues

If you experience issues with continuity not displaying correctly, try the following:

Ensure igniters are properly connected to the module.
Reattempt the continuity check after waiting a few moments.
Verify that your module is powered on and properly paired with the app.

Need more help? Contact us, we're always happy to assist!

Related to